Page 1 of 1

Step Entry (Pencil) for Chords

PostPosted: Wed May 14, 2014 5:06 am
by tsindt

I am new to Progression 2 and I have a problem to enter chordprogressions with the fretboard.
I am in the step entry mode and draw a chord on the fretboard, press enter and the chord will be drawn to the staff, but the fretboard will be cleared. In chapter 12 of the Manual, the chords stay on the fretboards if enter is pressed.

If I have to set an Option for that? Where is my fault?

Best regards,

Re: Step Entry (Pencil) for Chords

PostPosted: Wed May 21, 2014 2:24 am
by tsindt

nobody knows somthing about this behavier? :roll:

It is important for me to get this work, because it is very difficult to transcript rhythm guitar without this function.