Attention:

Welcome to the old forum. While it is no longer updated, there is a wealth of information here that you may search and learn from.

To partake in the current forum discussion, please visit https://forums.presonus.com

problem with the tonal range of instruments

A Forum to Discuss NOTION

problem with the tonal range of instruments

Postby wolf2 » Fri Apr 30, 2010 7:11 am

hi again,

here's a second thing I can't solve, I'm open for all advice:

"violins" e.g. as a notion-soundset refuses writing notes below A2, the miro-violins refuse writing notes below C3. later I can drag notes downwards, but for the first writing there seems to be a kinda tonal barrier. what am I doing wrong?

thanks in advance

wolf
wolf2
 
Posts: 10
Joined: Fri Dec 04, 2009 9:20 am

Re: problem with the tonal range of instruments

Postby wolf2 » Mon May 03, 2010 4:02 am

bump
wolf2
 
Posts: 10
Joined: Fri Dec 04, 2009 9:20 am

Re: problem with the tonal range of instruments

Postby ulrik » Mon May 03, 2010 6:00 am

wolf2 wrote:hi again,

here's a second thing I can't solve, I'm open for all advice:

"violins" e.g. as a notion-soundset refuses writing notes below A2, the miro-violins refuse writing notes below C3. later I can drag notes downwards, but for the first writing there seems to be a kinda tonal barrier. what am I doing wrong?

thanks in advance

wolf

Hi wolf!
What kind of input technic do you use?
I tried here with Notion violins and with Miro violins and I have no problems writing them below A2 and C3 using: Step input (with keyboard), live recording (keyb) but when I use mouse to insert them the symbol goes dimmed grey and I'm unable to insert them as you said, I also have to drag them down.
However when I allready have one note written below G3 I can go on and write with the mouse below G3....strange, it's like the "insert" area has expanded when there allready is one low note inserted.

I would say this is a bug.

regards / Ulrik
User avatar
ulrik
 
Posts: 203
Joined: Thu Feb 04, 2010 5:27 am
Location: Sweden

Re: problem with the tonal range of instruments

Postby wolf2 » Mon May 03, 2010 8:37 am

hi ulrik,

thanks for the confirmation that the strange behaviour with these "greyed out notes" is the same at your site. btw...I use as an input source the mouse.

dear notion team, it would be cool if this would be solved. thanks!

greetings

wolf
wolf2
 
Posts: 10
Joined: Fri Dec 04, 2009 9:20 am

Re: problem with the tonal range of instruments

Postby Unfinished » Mon May 03, 2010 8:43 am

Basically the height of each part will only allow notes to be inserted by mouse within a certain range. The height and range of a part is increased when there are notes of extreme enough ranges already present. If you think about it you can't expect to be able to input by mouse the highest note playable on the piano because that would mean the piano part would have to be very high (which would be a waste of space for almost everyone). What I have suggested before, though, is that Notion should make it so that when you have a note prepared as the cursor (ready to place in the score) and you move it up it should push a little into the above part's lower range before snapping to the above part when it is almost of top of its bottom line. Similarly, once it has snapped to the above part, as you drag the cursor down the point at which it snaps to the below part should be stretched. This would mean people would not have to place a note then move it up or down to the extreme pitch they wanted to place it at as much.
Unfinished
 
Posts: 167
Joined: Tue Jun 09, 2009 10:16 am

Re: problem with the tonal range of instruments

Postby 4tune » Mon May 03, 2010 8:59 am

Unfinished wrote:Basically the height of each part will only allow notes to be inserted by mouse within a certain range. The height and range of a part is increased when there are notes of extreme enough ranges already present. If you think about it you can't expect to be able to input by mouse the highest note playable on the piano because that would mean the piano part would have to be very high (which would be a waste of space for almost everyone). What I have suggested before, though, is that Notion should make it so that when you have a note prepared as the cursor (ready to place in the score) and you move it up it should push a little into the above part's lower range before snapping to the above part when it is almost of top of its bottom line. Similarly, once it has snapped to the above part, as you drag the cursor down the point at which it snaps to the below part should be stretched. This would mean people would not have to place a note then move it up or down to the extreme pitch they wanted to place it at as much.


Another possible idea to deal with this could be, to enable dragging of notes until the Left Mouse Button (LMB) is released:

-Currently a note is committed to the score on the LMB click. You then have to press escape to drag the note that you have just written. It could be that until the LMB is released it is possible to drag the note to a new position . i.e. in this case to the extremes of a register.

-Alternatively a modifier could be used for a similar thing. Press Alt and the cursor will go to an arrow, you can drag the note; Release Alt and the cursor returns to crotchet (or whatever note was selected before).

Alt becomes a temporary escape. ( I can see other uses for Alt as a temp escape also, time for a separate FR I think :) )
4tune
 
Posts: 150
Joined: Thu Nov 05, 2009 3:01 pm

Re: problem with the tonal range of instruments

Postby wolf2 » Mon May 03, 2010 11:18 am

Unfinished wrote:Basically the height of each part will only allow notes to be inserted by mouse within a certain range. The height and range of a part is increased when there are notes of extreme enough ranges already present. If you think about it you can't expect to be able to input by mouse the highest note playable on the piano because that would mean the piano part would have to be very high (which would be a waste of space for almost everyone). What I have suggested before, though, is that Notion should make it so that when you have a note prepared as the cursor (ready to place in the score) and you move it up it should push a little into the above part's lower range before snapping to the above part when it is almost of top of its bottom line. Similarly, once it has snapped to the above part, as you drag the cursor down the point at which it snaps to the below part should be stretched. This would mean people would not have to place a note then move it up or down to the extreme pitch they wanted to place it at as much.


thanks for that hint! so my makeshift is now to put a dynamics mark at the beginning of each track...that expands the height downwards.
anyway, fixing that problem would be better.

your proposals make sense, mr. unfinished and mr. 4tune.

greetings

wolf
wolf2
 
Posts: 10
Joined: Fri Dec 04, 2009 9:20 am

Re: problem with the tonal range of instruments

Postby David Smith » Sun May 09, 2010 5:46 pm

Another way to get to extreme ranges is to put in a note, and then move it way down, allowing subsequent notes to be entered. I put in a note, then use the arrow key to move it down. I agree it would be nice to drag while entering.
David Smith
 
Posts: 98
Joined: Sat Feb 27, 2010 12:44 am
Location: California


Return to NOTION

Who is online

Users browsing this forum: Google [Bot] and 21 guests


cron