Page 2 of 2

Re: multi-measure rest ......

PostPosted: Mon May 26, 2014 1:27 pm
by robe1972
Thank you very much..!
Best regarde

Re: multi-measure rest ......

PostPosted: Sat May 31, 2014 10:56 am
by Johnny
Johnny wrote:
robe1972 wrote:Why choose numbers in function multi- measure rest?
In the file that I posted, there is a bar (131) alone in one system....why?


That's a good question.

I believe it should be an on/off function. The number changes nothing that I can detect.
It is either "none" or (on = any number you input).
A quirk that's not fixed, repaired or changed as of Notion 4.


I now think that it sets the minimum amount of measures for Multi-measure rests. If set to "4" for example any areas of 4/or more rests will show as MM-rests. any less then 4 will show as empty measures or if you added a whole rest etc. it will show them instead of the MM-rest. Not quite sure I haven't try it completely yet.

,Johnny

:arrow: